You probably realize toothbrush handles are injection-molded pieces of plastic. But how do they get the nylon bristles into the head? And without using adhesive, how do they get the bristles to stay put?

Here's how. This is a shot of the machine that loads the bristles into the heads, at actual speed:

Here's the process from a different angle, slowed down:

The close-up in slow motion, below, provides the answer. The tool that grabs the bristles also folds them in half (off camera) and binds them into a bunch by wrapping them with wire near the fold. In this shot below, you can see the wire binding that's holding the butt end of the bristles.

The wire binding provides a friction fit in the molded holes, both keeping the bristles together and preventing them from falling out.

Video of the full process below.

https://youtu.be/B2IMASYxrAs Or for a more bespoke process.

I have wondered about this FOREVER!  Thanks for putting it in front of me Rain.

I’m a lapsed industrial designer. I was born in NYC and figured I’d die there, but a few years ago I abandoned New York to live on a farm in the countryside with my wife. We have six dogs.

Test it out; it only takes a single click to unsubscribe

Don't have an account? Join Now

Already have an account? Sign In

By creating a Core77 account you confirm that you accept the Terms of Use

Please enter your email and we will send an email to reset your password.

Test it out; it only takes a single click to unsubscribe